|
| Section II. MAINTENANCE PROCEDURES
Subject
Para.
Page
General ................................................................................................................................................ 3-4
Battery Power Supply
Removal/Replacement......................................................................................................................... 3-5
Battery Charging Procedure ................................................................................................................. 3-6
Battery Removal/Replacement............................................................................................................. 3-7
Edge Lamp Removal/Replacement ...................................................................................................... 3-8
3-4. General
This section contains the maintenance operations required to service your Radio Set Perform these procedures when
referenced in Section I
3-5. Battery Power Supply
Removal/ Replacement
WARNING
The snap fasteners shown in figure 3-1 are spring loaded.
To avoid pinched
fingers, use care when snapping or unsnapping fasteners.
To remove or install the battery power supply, refer to Figure 3-1. position R/T unit power switch to OFF and perform the
following steps.
3-11
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |