|
| NOTE
Higher charge levels can be obtained by keeping the batteries and case at +70
(+220C) or below.
3-7. Battery Removal/Replacement
Figure 3-3 shows how the batteries are mounted in the battery power supply. To remove or replace the batteries,
proceed as follows.
a. Pull the two Velcro strips that hold the battery insert in the battery case upward and outward until they are
fully separated.
b. Pull the pull ring on the battery insert and remove the insert from inside the case.
c. Pull each battery (there are two) straight out from the insert so that they slide free from their connectors.
d. To replace a battery, line up the plugs on the battery and battery insert and push the battery fully into the
insert.
e. Carefully place the battery insert into the battery case and fasten the two Velcro strips.
3-16
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |