Click here to make tpub.com your Home Page

Page Title: Transmitter, Radio T-1054(P)/GRC144(V) and T-1054(P)A/GRC-144V) Repairs
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



TM 11-5820-695-35
(2) Set the POWER ON/OFF switch on meter panel
3-20. Transmitter, Radio T-1054(P)/GRC144(V) and T-
assembly 1A15A8 to ON.
1054(P)A/GRC-144V) Repairs
(3) Make the following checks on T-1054(P)/GRC-
Procedures required to remove or replace parts which are
144(V) :
not obvious or require special handling are given in
(a) The 5 AMP SLO-BLO neon fuse indicator
paragraph 3-21 through 3-37.
Prior to removal or
on meter panel assembly 1A15A8 is not lighted.
replacement of any part in the T-1054 (P)/GRC-144(V) or
(b) All power supply 1A1 indicator lamps are
T-1054(P)A/GRC-144(V)  the  procedures  for  power
lighted green.
removal given in paragraph 3-20a unless otherwise
(c) 5V and 28V indicator lamps on electrical
stated, must be performed.  Procedures for restoring
frequency synthesizer 1A14 are lighted green.
power are given in paragraph 3-20b.  Procedures for
(4) Set the POWER ON/OFF switch on meter panel
removal and replacement of components with rigid
assembly 2A15A2 to on (fig. 3-17).
coaxial cables are covered in TM 11-5820-696-12.
(5) Make the following checks on R1467/GRC-144:
(a) The SLO-BLO POWER 5 AMP and
a. Remove Power.
TDA 1 AMP neon fuse indicators on meter panel
(1) Set the POWER ON/OFF switch on meter panel
assembly 2A15A2 are not lighted.
assembly 2A15A2 to OFF (fig. 3-17).
(b) All power supply 2A1 indicator lamps
(2) Set the POWER ON/OFF switch on meter panel
are lighted green.
assembly 1A15A8 to OFF (fig. 3-1).
(c) 5V and 28V indicator lamps on
(3) Disconnect the external ac po er source cable
w
electrical frequency synthesizer 2A14 are lighted green.
from AC POWER INPUT connector 1A15A6J18 located
on the top rear section of the electrical equipment cabinet
NOTE
b. Restore Power.
Radio communications can normally
(1) Reconnect the external ac power source cable to
be established 5 to 10 minutes after
AC POWER INPUT connector 1A15A6J18 located on top
AN/GRC-144(V) Radio Sets are turned
rear section of electrical equipment cabinet 1A15.
on if the ambient temperature in the
shelter  is  maintained  above  +70
Fahrenheit.
Change 6 3-31


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business