TB 9-2320-387-35-6
NOTE
Position convoluted conduit through C-partition cutout, around
wheelhouse armor to tunnel.
8-12. Install twenty inches of convoluted conduit (19) on EPLRS power cable (10) and INC-EPUU
cable (7).
8-13. Route EPLRS power cable (10) and INC-EPUU cable (7) along interface plate (11) and through
access hole in cargo wall (22).
8-14. Secure EPLRS power cable (10) and INC-EPUU cable (7) to interface plate (11) with three
clamps (16), capscrews (12), lockwashers (13), washers (14), and washers (15).
8-15. Remove two nuts (17) and washers (18) from studs of capscrews (21) on cargo wall (22).
8-16. Secure EPLRS power cable (10) and INC-EPUU cable (7) to cargo wall (22) with two clamps (20),
existing stud of capscrews (21), washers (18), and nuts (17).
8-17. Install spiral wrap (9) on cables (7) and (10).
8-18. Secure spiral wrap (9) on cables (7) and (10) with electrical tape (8).
12
13
12
14
13
16
22
14
9
15
8
21
20
12
18
17
13
14
21
20
15
19
18
7 10
17
16
~
11
16. LOOP CLAMP MS21333-104 QTY. 3
8.
ELECTRICAL TAPE HH-I-595-A-108-0 QTY. A/R
17. LOCKNUT M45913/4-6CG8Z QTY. 2
9.
SPIRAL WRAP 11644992 QTY. 8 IN.
12.
CAPSCREW B1821BH025C100N QTY. 3
19. CONVOLUTED CONDUIT, 19 mm M1889006
13.
LOCKWASHER MS35338-44 QTY. 3
QTY. 20 INCHES
14.
WASHER MS27183-10 QTY. 3
20. LOOP CLAMP MS21333-125 QTY. 2
15.
WASHER MS51412-36 QTY. 3
Figure 5-63.
5-52