PREPARATION FOR SHIPMENT OR STORAGE.

TB 11-5820-890-12

STEP 1

Using your fingers, carefully pry up one comer of the rubber keypad.

STEP 2

Carefully lift the pad away from the case until it is free from the ANCD.

STEP 3

Fit the new keypad into the cavity and gently press the pad into the recessed area until the pad

is fully seated.

STEP 4

Turn the ANCD on and test the keypad for operation.

4-22. REPLACEMENT.

The battery must be replaced when low bat indicator is illuminated. To replace the battery, follow the procedures of

4-23. SOFTWARE.

There is no unit-replaceable software. The ANCD must be returned to SRA/Depot for application software reload.

4-24. PREPARATION FOR SHIPMENT OR STORAGE.

To prepare the ANCD for shipment or storage, perform the following steps:

(1)

Zeroize the ANCD to remove data from memory locations.

(2)

If the ANCD is going into long-term storage, remove batteries (refer to Figure 3-1).

(3)

Repack the ANCD in reverse order of the steps shown in Paragraph 2-7 and Table 2-1.

4-15