|
| mendations for improving this publication by the
per hundred units, whichever is applicable, speci-
fied for a given group of defects of a product. It is
individual user is encouraged. Reports shall be sub-
the maximum allowable accidental departure from
mitted on DA Form 2028 (Recommended Changes
specification requirements which can be tolerated.
to Publications) and forwarded direct to U.S. Army
Electronics Command ATTN: AMSEL-MA-AC, Fort
5. Reporting of Supply Bulletin Improvements.
The reporting of errors, omissions, and recom-
Monmouth, NJ. 07703.
SECTION II.
STORAGE AND SPECIAL INSTRUCTIONS
number or the rebuild lot number.
6. Preservation, Packaging, and Packing. Pre-
c. Shelf Life. The radio set is subject to deteriora-
servation, packaging, and packing of the radio set
tion during storage and is required to be inspected
shall be in accordance with the requirements listed
and tested as specified in appendix D.
in appendix C. All items shall be preserved and
d. Tests. All test requirements for the radio set
packaged in accordance with MIL-STD-726C; pack-
along with the Federal stock numbers of each unit
ing shall conform to the requirements specified in
MIL-P-55585(EL).
are given in appendix B.
e. Precautionary Actions. When the radio set is
7. Marking. In addition to any special marking, re-
being prepared for storage or issue be sure that
quired by the contract or order, interior packages
there are enough personnel and sufficient moving
and exterior shipping containers shall be marked in
apparatus available to eliminate the possibility of
accordance with MIL-STD-129D.
damage to the equipment or injury to the personnel.
8. Storage. a. Type. The preferred type of storage
9. Disposition of Rejected Materiel. Rejected
environment for the radio set is a controlled humid-
materiel will be tagged and reclassified into the
ity warehouse or heated warehouse.
proper condition code in accordance with AR 725-50.
b. Age Control. The radio set will be issued on a
For other than new material all defective units in
first-in-first-out (FIFO) basis by date of manufac-
a lot shall be repaired, or disposition requested in
ture, or date of rebuild. The dates can be established
accordance with AMC and depot procedures.
from the original government procurement contract
APPENDIX A
REFERENCES
MIL-B-117
Interior Packaging, Bags, Sleeves and Tubing
Packing and Marking Requirements for Southeast Asia and
MIL-P-55585(EL)
Stratcom and Preparation Delivery Requirements of
Electronic Equipment and Components
Quality Assurance Terms and Definitions
MIL-STD-109B
Packaging Requirements Code
MIL-STD-726C
Storage and Materiels Handling
TM 743-200-1
Marking for Shipment and Storage
MIL-STD-129D
APPENDIX B
FEDERAL STOCK NUMBERS AND TEST REQUIREMENTS
Test Requirements
Publication
FSN
Type
RECEIVER-TRANSMITTER
Paragraphs 6-5 and 6-6
TM 11-5820-518-35
RT-742(*)/ARC-51BX
5821482-3927
Radio Set Control
Paragraph 6-7
TM 11-5820-518-35
C-4677/ARC-51X
5820482-3700
Radio Set Control
Paragraph 6-8
TM 11-5820-518-35
5821-082-3928
C-6287/ARC-51BX
APPENDIX D
SB 740-5821-91406
Bench Tests
N/A
*Denotes all models of a particular equipment are covered in this bulletin.
2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |