|
| TM 32-5895-206-10
(a) CW setting. If level of incoming signal is
stable, set VOL control at about 3/4 clockwise and vary sound
level using RF GAIN control. If level is varying, use (b) below.
(b) FM and AM setting. Set the RF GAIN
control to AVC (fully clockwise) and vary sound level using VOL
control.
(6) Use good tactical judgment to avoid detection and
conserve batteries when using receiver dial light. Hold LITE
switch to M ON for momentary use. Set LITE switch to ON for
continuous use (external power only). Set LITE switch to OFF
when light is not needed.
c. Sound Recorder/Reproducer AN/PNH7.
(1) Be sure mode selector switch is set to OFF before
making or removing connections or loading or removing
cassettes. Be sure recorder/reproducer is ready as described
above.
(2) Listen to signal with headset during record and
reproduce modes of operation. When end of tape is reached in
those modes, recorder/reproducer will stop and make a signal
tone in headset.
(3) To make a recording of a received radio signal, set
AGC/MAN switch to AGC. Press in mode selector switch. Press
2-59
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |