OPERATING PROCEDURES (cont)

TM 32-5895-206-10

(4) Adjust TUNE control to tune in desired signal.

Press tuning control for fast scan tuning. Do not press tuning

control for fine tuning. Fine tune receiver for best sound quality.

(5) Set VOL and RF gain controls as follows:

(a) LSB and USB settings. If incoming signal

strength is stable, set VOL control about 3/4 clockwise and vary

sound level using RF gain control.

(b) LSB and USB settings. If incoming signal

strength is varying, set RF gain control to AVC (fully clockwise)

and vary sound level using VOL control.

clockwise) and vary sound level using VOL control.

(6) If it is necessary to switch bands or frequencies

during operation, it may be necessary to recalibrate tuning dial

for maximum accuracy.

(7) Use good tactical judgment to avoid detection and

conserve batteries when using receiver dial light. Hold LITE

switch to M ON for momentary use. Set LITE switch to ON for

continuous use (external power only). Set LITE switch to OFF

when light is not needed.

2-57