Recorder/Reproducer

TM 32-5895-206-10

the FUNCTION switch to CAL. Turn the TUNE control to the

calibration mark nearest the desired operating frequency. Tune

in the calibration signal by turning the TUNE control slightly to

either side of the calibration mark. Use the headset and panel

meter to detect the signal. Turn the CAL ADJ control to realign

the tuning scale cursor with the calibration mark. Turn the

FUNCTION switch to OFF. Turn the ANT switch to the desired

antenna input. Turn the TUNE control to the exact operating

frequency. Disconnect the headset.

Calibration Frequencies

R-1218/UR:

0.6 to 4.8 MHz, 0.1 MHz intervals,

5.0 to 20.5 MHz, 0.5 MHz intervals

R-1518/UR:

2.0 MHz intervals

c. Recorder/Reproducer. Be sure the mode selector

switch is in the OFF position. Release the strap over the

cassette loading door, release the door latches, and open the

cassette loading door.

If a cassette is in the cassette

compartment, push the EJECT button and remove the cassette.

Install a fresh cassette with the full spool to the left of the

cassette compartment. (The side marked 1 should face up.)

Close the loading door and secure the latches. The strap may

2-51