|
| TM 32-5895-206-10
(8) Place recorder/reproducer with attached battery
assembly on packboard and secure them with two straps. If
recorder/reproducer will be used immediately, only fasten strap
over battery assembly. Reconnect cords to recorder/reproducer.
2-7 PRELIMINARY STARTING PROCEDURES.
Before
operation, perform the following procedures.
a. Receiver Control Settings.
Set the controls of the
receiver(s) as follows:
Control
Settings
FUNCTION switch
OFF
VOL control
Midrange
BAND switch
Desired band
TUNE control
Desired frequency
(approximately)
LITE switch
OFF
RF GAIN control
Fully clockwise
POWER switch (rear)
INT
b. Receiver Calibration. Perform this procedure when the
receiver dial must be accurately set or the exact operating
frequency must be known. Set the ANT switch to an unused
antenna input. Attach the headset to the AUDIO connector. Set
2-50
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |