|
| TM 11-5895-1141-34
Section III. PERFORMANCE CHECK
SECTION CONTENTS
Page
System Test Procedure ...........................................................................................................
4-8. SYSTEM TEST PROCEDURE
a. The test procedures that follow are used to periodically check the performance of the radio channel control
system. Normal test data are provided as part of the test procedures. Check your test data against the normal data to
determine the quality of the system performance.
b. Perform the tests listed in the charts that follow, step by step. The left hand column denotes the order (Step) in
which the test must be performed. The next column (Operation) describes the test procedure. The Normal Indication
column denotes the correct test result you should observe. In the event your test results do not conform to the Normal
Indication, corrective action should be taken. Three charts are provided which allows you to perform separate tests on the
transmitter circuits, receiver circuits, and where appropriate, the recorder/monitor circuits.
c. When performing these system test procedures following installation or following major changes in wiring between
positions or between the radio channel control equipment and the lines to the radio equipment, the crosstalk tests
described in table 4-9 should be performed in addition to the aforementioned test procedures.
NOTE
If an MTS-2400 module test set is available, then with
the exception of the crosstalk tests, paragraph 4-8
should be ignored and the test procedure of paragraph
4-6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |