 |
|||
|
|
|||
|
Page Title:
Section II. Disassembly and Reassembly |
|
||
| ||||||||||
|
|  TM
11-5820-919-40-1
SECTION
II
DISASSEMBLY
AND
REASSEMBLY
3.
Disconnect the color-coded rf
RECEIVER/EXCITER
DISASSEMBLY
cables (6) A2J1, A2J2 from the harmonic
filter module (4).
Procedures for disassembly of the
5-6.
4.
Loosen the 4 captive screws (3) on
receiver/exciter consist of removing the
the harmoic filter module (4).
five modules A1A1 thru A1A5 and ribbon
cable W1.
5.
Grasp the wire handle on top of
the module (4) and pull gently upward to
CAUTION
remove the module.
SYNTHESIZER
A1A3
REMOVAL.
If Radio is being disassembled
for the first time, apply heat
Place the radio so that the cover
1.
to screws to loosen loctite
assembly (12) is on top.
compound.
2.
Remove the cover assembly (12) by
loosening the 8 captive screws (13).
CAUTION
3.
Disconnect the color-coded rf
When removing modules (except
cables (9) A3J1, A3J2, and A3J3 from the
for power supply), pull
synthesizer module (10).
Do not rock.
straight up.
4.
Loosen the 5 screws (11) on the
synthesizer module (10).
MODULATOR/DEMODULATOR
A1A1
5.
Grasp the wire handle on the
REMOVAL .
module (10) and pull gently upward to
Place the receiver/exciter so that
1.
remove the module.
cover assembly (1) is on top and, when
facing the control panel, the control
POWER
SUPPLY
A1A5
REMOVAL.
knobs read right side up.
1.
To remove the power supply module
Remove the cover assembly (1) by
2*
(15), the synthesizer module (10) must
loosening the 8 captive screws (2).
first be removed.
Refer to paragraph
Disconnect the color-coded rf
3.
5-9 for removal of synthesizer.
cables (17) A1J1, A1J2, A1J3, and A1J4
from the module (18).
Remove the 4 captive screws (14)
2.
holding the power supply module (15) and
4. Loosen the 4 captive screws (19)
shield to the receiver/exciter housing
on the modulator/demodulator module
(8).
(18).
5.
Grasp the wire handle on top of
the module (18) and pull gently upward
CAUTION
to remove the module from the receiver/
exciter housing (8).
Improper removal of power
supply may cause damage to
FILTER
A1A2
REMOVAL.
multipin connector.
Place the receiver/exciter so that
1.
access cover is on top and the control
panel and the control knobs read right
3.
Grasp the wire handle and gently
side up.
ease the module (15) and shield back-
wards out of the plug before lifting
2.
Remove the cover assembly (1) by
upward.
loosening the 8 captive screws (2).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals