|
| |
TM 11-5820-890-30-5
16-11. REPLACEMENT OF J1, J2, J3, OR J4 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
f. Connector terminals
g.
h.
Tiedown straps (13)
Eight screws (5)
and Iockwashers (6)
16-12. REPLACEMENT OF J5
Tools:
Flat tip screwdriver
Adjustable wrench
Expendable supplies:
Silicone compound
Alcohol
References:
Use soldering kit. Solder wires to correct
NOTE
terminals of connector. If necessary, slide
Ensure each wire has insu-
insulation sleeving down over connection,
Iation sleeving on it
and apply heat to it until it shrinks tight
if necessary, and
around the connection.
each wire is placed through
mounting hole in connector
case (12). While soldering
wires, attach heat sink to
bare wire between insula-
tion sleeving and terminal.
Before and after soldering,
clean wires and terminals
with cotton swabs
and alcohol.
Replace any tiedown straps (13) that
were removed.
Use cross tip screwdriver. Install and
hand tighten eight screws (5) and
Iockwashers (6) securing access
cover (1) to connector case (12).
Use torque screwdriver. Torque
screws to 8 to 10 in-lb.
CONNECTOR.
Soldering kit
Cotton swabs
Solder
Paragraph 16-16 for removal and installation of threaded screw inserts.
If a screw is not stripped
but will not tighten, refer
to paragraph 16-16 for
replacement of its threaded
screw insert (if present).
If a tapped hole is defec-
tive, refer to paragraph
16-10 for replacement of
the connector case (12).
ITEM
ACTION
REMARKS
REMOVAL
a. Electrical connector
assembly (9A1)
Set on work surface with J5 connector
(16) toward you. See figure 16-3.
16-11
|
