|
| |
TM 11-5820-890-30-5
16-11. REPLACEMENT OF J1, J2, J3, OR J4 CONNECTOR.
Tools:
Cross tip screwdriver
1-1/4-inch spanner wrench attachment
Torque screwdriver
Soldering kit
Torque wrench
Spanner wrench
Expendable supplies:
Silicone compound
Alcohol
Cotton swabs
Solder
References:
Paragraph 16-16 for removal and installation of threaded screw inserts.
ITEM
ACTION
REMARKS
REMOVAL
a. Eight screws (5) and
Use cross tip screwdriver. Remove and
Inspect each screw and its
Iockwashers (6)
inspect eight screws (5) and lockwash-
threaded screw insert (if
ers (6) securing access cover (1) to
present) to determine if
connector case (12). If damaged,
any is defective. If a screw
obtain replacement. Lay
to one side. See figure
access cover
is stripped, do not replace
16-3.
its threaded screw insert.
b. Tiedown straps (13)
c. J1 (7), J2 (10),
J3 (8), or J4 (9)
connector wires
d. Connector
INSTALLATION
e. J1 (7), J2 (10),
J3 (8), or J4 (9)
connector
If the holes are tapped,
there will be no threaded
screw insert.
Remove any tiedown straps that are
in the way.
Record location of wires soldered
to terminals of connector.
Use soldering kit. Desolder each wire con-
NOTE
netted to connector. Inspect insulation
Place heat sink on bare
sleeving as required. If damaged, obtain
part of wire just above
replacement.
area to be resoldered.
Remove and discard defective
connector.
Obtain replacement connector.
16-10
|
