|
| |
TM 11-5820-890-30-5
16-12. REPLACEMENT OF J5 CONNECTOR. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
b. Two screws (14)
Use flat tip screwdriver. Remove and
inspect two screws (14) securing J5
connector (16) to connector case (12).
If damaged, obtain replacement.
c. Guide pin (15)
Use adjustable wrench. Remove and
inspect guide pin (15) securing J5
connector (16) to connector case (12).
If damaged, obtain replacement.
d. J5 connector (16)
Gently pull out top of J5 connector (16).
e. J5 connector (16) wires
Record location of wires soldered to
terminals of J5 connector (16).
Use soldering kit. Desolder each wire
connected to J5 connector (16).
f. J5 connector (16)
INSTALLATION
g. J5 connector (16)
h. Connector case (12)
i.
J5 connector (16)
terminals
j.
Tiedown strap (13)
k. Neoprene gasket
l.
Two screws (14) and
guide pin (15)
Remove and discard defective J5
connector (16).
Obtain replacement J5 connector (16).
Position J5 connector (16) next to
mounting hole in connector case (12).
Use soldering kit. Solder wires to correct
terminals of connector.
Replace tiedown strap (13) if removed.
Coat the neoprene gasket of J5 con-
nector (16) with silicone compound,
and place the connector in mounting
hole of connector case (12).
Use flat tip screwdriver and adjustable
wrench. Install and hand tighten two
screws (14) and guide pin (15) secur-
ing J5 connector (16) to connector
case (12).
Inspect each screw and its
threaded screw insert to
determine if any is defec-
tive. If a screw is stripped,
do not replace its threaded
screw insert.
Inspect guide pin and its
threaded screw insert to
determine if either is de-
fective. If guide pin is
stripped, do not replace
its threaded screw inserts.
If necessary, remove
tiedown strap (13).
NOTE
Place heat sink on bare
part of wire just above
area to be resoldered.
NOTE
Before and after soldering,
clean wires and terminals
with cotton swabs and
alcohol.
If a screw or the guide pin
is not stripped but will not
tighten, refer to paragraph
16-16 for replacement of
its threaded screw insert.
16-12
|
