|
| |
TM 11-5820-890-30-5
16-10. REPLACEMENT OF CONNECTOR CASE. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
h. Three (or two) screws
Use cross tip screwdriver. Remove and
NOTE
(25), flat washers (24),
inspect three (or two) screws (25), flat
For versions with a
and Iockwashers (23)
washers (24), and Iockwashers (23)
FILTER EMI-CCA there
securing filter mounting plate (22) or
will be hardware for only
FILTER EMI-CCA to connector case (12).
two holes after removal
If damaged, obtain replacement.
of ground lug in step g.
i.
Filter mounting plate (22)
Remove filter mounting plate (22) or
or FILTER EMI-CCA,
FILTER EMI-CCA, and wiring harness from
and wiring harness
connector case (12). If damaged,
obtain replacement.
j.
Seal screw (11)
Use flat tip screwdriver. Remove seal
screw (11) from connector case (12),
and inspect it. If damaged, obtain
replacement.
k. Connector case (12)
INSTALLATION
l.
Connector case (12)
m. Seal screw (11)
Discard defective connector case (12).
Obtain replacement connector case (12).
Use flat tip screwdriver. Install and hand
tighten seal screw (11) in connector
case (12).
n. Filter mounting plate (22)
Place filter mounting plate (22)
or FILTER EMI-CCA,
or FILTER EMI-CCA, and wiring
and wiring harness
harness in connector case (12).
o. Three (or two) screws
Use cross tip screwdriver. Install and
NOTE
(25), flat washers (24),
hand tighten three (or two) screws (25),
For versions with a
and Iockwashers (23)
flat washers (24), and Iockwashers (23).
FILTER EMI-CCA two
sets of hardware are
installed on the side of
the CCA that contains
two holes.
16-8
|
