|
| |
TM 11-5820-890-30-5
Soldering kit
16-10. REPLACEMENT OF CONNECTOR CASE.
Tools:
Cross tip screwdriver
Adjustable wrench
Flat tip screwdriver
Heat sink
Expendable supplies:
Silicone compound
Cotton swabs
Sealing compound,
Alcohol
grade H
Solder
References:
Paragraph 16-16 for removal and installation of threaded screw inserts.
ITEM
ACTION
REMARKS
REMOVAL
a.
Eight screws
Iockwashers
(5) and
Use cross tip screwdriver. Remove and
(6)
inspect eight screws (5) and lockwash-
b. Two screws (14)
c. Guide pin (15)
d.
e.
ers (6) securing access cover (1) to
connector case (12). If damaged,
obtain replacement. Lay access cover
to one side. See figure 16-3.
Use flat tip screwdriver. Remove and
inspect two screws (14) securing J5
connector (16) to connector case
(12). If damaged, obtain replacement.
Use adjustable wrench. Remove and
inspect guide pin (15) securing J5
connector (16) to connector case
(12). If damaged, obtain replacement.
J5 connector (16)
Gently pull out top of J5 connector
(16).
J5 connector (16) wires
Record location of wires soldered to
terminals of J5 connector (16).
f. J5 connector (16)
g. Screw (19) and
Iockwasher (18)
Use soldering kit. Desolder each wire
connected to J5 connector (16).
Remove J5 connector (16) from connector
case (12), and inspect it for damage.
If damaged, obtain replacement.
Use cross tip screwdriver. Remove and
inspect screw (19) and Iockwasher (18)
securing E1 terminal lug (17) next to
filter mounting plate (22). If damaged,
obtain replacement. See note.
If necessary, remove
tiedown strap (13).
NOTE
Place heat sink on bare
part of wire just above
area to be resoldered.
NOTE
For versions with a FILTER
EMI-CCA this terminal lug
is screwed to the CCA and
connector case.
16-7
|
