|
| |
TM 11-5820-890-30-5
14-23. REPLACEMENT OF P1 CONNECTOR.
Tools:
Flat tip screwdriver
Soldering kit
Torque screwdriver
Soldering aid
Flat tip bit
Heat sink
Expendable Supplies:
Solder
Alcohol
Cotton swabs
Sealing compound
ITEM
ACTION
REMARKS
REMOVAL
a.
Power supply adapter
Set on work surface with rear
toward you. See figure 14-4.
b.
12 captive screws (3)
Use flat tip screwdriver. Fully loosen
and inspect for damage.
If damaged, obtain replacement.
c.
Rear access cover (2)
Remove from chassis to allow access to
P1 connector, and retain.
d.
Connector (9) wires
Use soldering kit, soldering aid, and
heat sink. Tag the location of all wires
on defective connector. Unsolder each
wire from the connector.
e.
Four screws (10)
Use flat tip screwdriver. Remove and
inspect four screws securing connector
to rear access cover.
If damaged, obtain replacement.
f.
Connector retaining
Remove from rear access cover and
plate (11)
inspect for damage. If damaged, obtain
replacement.
g.
Connector (9)
Remove and discard defective connector.
14-37
|
