|
| |
TM 11-5820-890-30-5
14-22. REPLACEMENT OF J5 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION
h.
Connector (6) and
Iockwasher
i.
O-ring
j. Hex nut and
Iockwasher
Obtain replacement connector and
Iockwasher.
Apply silicone compound to o-ring
on replacement connector.
Use 1 1/16 inch socket wrench.
Install and hand tighten retained
hex nut and replacement Iockwasher
securing the connector to the access
cover. Use torque wrench and 1 1/16 inch
socket. Torque to 70 in-lb.
k.
Connector (6) wires
Use soldering kit, soldering aid, and
Before and after soldering,
heat sink. Solder tagged wires to
clean wires and connector
correct connector pins, and remove
pins with alcohol and
wire tags.
cotton swabs.
l.
Rear access cover (2)
Position retained rear access cover on
the power supply adapter chassis.
m. 12 captive
Use flat tip screwdriver. Install and
screws (3)
hand tighten the 12 captive screws
securing the rear access cover to the
power supply adapter chassis. Use
torque screwdriver. Torque to 9 in-lb.
n.
Protective cap (7)
Install the protective cap on the
connector.
14-36
|
