|
| |
TM 11-5820-890-30-5
14-22. REPLACEMENT OF J5
Tools:
Flat tip screwdriver
Torque screwdriver
Flat tip bit
CONNECTOR.
Soldering kit
Soldering aid
Heat sink
1 1/16 Inch socket wrench
Torque wrench
1 1/16 Inch socket
Expendable Supplies:
Solder
Alcohol
Cotton swabs
Silicone compound
ITEM
ACTION
REMARKS
REMOVAL
a.
Power supply adapter
Set on work surface with rear toward
you. See figure 14-4.
b.
12 captive screws (3)
Use flat tip screwdriver. Fully loosen
and inspect for damage.
If damaged, obtain replacement.
c.
Rear access cover (2)
Remove from chassis to allow access to
J5 connector, and retain.
d.
Protective cap (7)
Remove from defective connector (6),
and retain.
e.
Connector (6) wires
Use soldering kit, soldering aid, and
heat sink. Tag the location of all wires
on defective connector. Unsolder each
wire from the connector.
Use 1 1/16 inch socket wrench.
Remove and retain hex nut securing
connector to rear access cover.
Remove and discard defective connector
and Iockwasher.
f.
Hex nut
g.
Connector (6) and
Iockwasher
14-35
|
