|
| |
TM 11-5820-890-30-5
4-23. REPLACEMENT OF ELECTRICAL BINDING POSTS E1A, E2A, E1B, AND E2B. Continued
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting adapter
Set on work surface with right side
toward you.
b. Access cover (2)
Remove.
c. Wires
Using soldering kit, tag and desolder wires
from defective binding post (7).
d. Binding post (7)
Using 5/16-inch open-end wrench, re-
move and discard nut and Iockwasher
(8) securing terminal lug (9) to defective
binding post. Remove and discard de-
fective binding post from audio amplifier
chassis (5).
INSTALLATION
e. Binding post (7)
f. Wires
Position replacement binding post to audio
amplifier chassis (5). Install terminal lug
(9) to binding post. Position replacement
nut and Iockwasher (8) on binding post.
Using 5/16-inch open wrench tighten nut.
Using soldering kit, solder tagged wires
to replacement binding post. Remove
wire tags.
g .
Access cover (2)
Install.
See figure 4-5. Refer to
paragraph 4-19 for access
cover removal procedures.
See figure 4-8.
A replacement nut and
Iockwasher comes with
replacement binding post.
Before and after soldering,
clean wires and binding
post with alcohol and
cotton swabs.
See figure 4-5. This was
removed in step b.
Refer to paragraph 4-19 for
access cover installation
procedures.
4-110
|
