|
| |
TM 11-5820-890-30-5
2-46. REPLACEMENT OF RT CHASSIS (1A16). Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
h.
i.
j.
k.
RT front panel assembly
Seal screw
COMSEC connector cover
COMSEC connector align-
ment plate
INSTALLATION
l.
m.
n.
o.
p.
q.
r.
s.
t.
u.
v.
COMSEC connector align-
ment plate
COMSEC connector cover
Seal screw
RT front panel assembly
Modules (1A1 through
1A15)
RF cables (1W1 through
1W5)
Cable ties
Hub cover
Two hub cover captive
screws
RT bottom cover
RT top cover
Use flat tip screwdriver. Remove and
Refer to paragraph 2-49 for
retain.
removal of RT front panel.
Use flat tip screwdriver. Remove and
retain.
Use cross tip screwdriver. Remove and
retain screw, flat washer, Iockwasher,
and cover.
Use cross tip screwdriver. Remove and
retain screw, flat washer, Iockwasher,
and alignment plate.
Use cross tip screwdriver. Install retained
screw, flat washer, Iockwasher, and align-
ment plate.
Use cross tip screwdriver. Install retained
screw, flat washer, Iockwasher, and cover.
Use flat tip screwdriver. Install retained
seal screw.
Use flat tip screwdriver. Install retained
RT front panel assembly.
Where necessary, use round nose pliers
and flat tip screwdriver. Install all modules.
Use round nose pliers. Install all retained
RF cables.
Install cable ties at locations where
removed.
Set retained hub cover in place on chassis.
Use flat tip screwdriver. Thread and tighten.
Refer to paragraph 2-49
for installation of RT front
panel.
Refer to paragraphs 2-36
through 2-44 for installation
of modules. See figure
2-15 for module locations.
Refer to paragraph 2-45 for
installation of RF cables.
See figure 2-17 for cable
locations.
These were removed in
step e.
Install.
Refer to paragraph 2-35
for installation of bottom
cover.
Install.
Refer to paragraph 2-35 for
installation of top cover.
2-172
|
