|
| |
TM 11-5820-890-30-5
2-47. REPLACEMENT OF DATA ENTRY KEYBOARD.
Tools:
Needle nose pliers
Cross tip screwdriver
Expendable supplies:
Silicone compound
References:
Figure 2-18 for location of screws.
ITEM
ACTION
REMARKS
REMOVAL
a. RT
Stand on work surface with front panel
up.
b. Four screws and flat
Use cross tip screwdriver. Remove and
See figure 2-18 for screw
washers
retain four screws and flat washers
locations.
securing keyboard to front panel.
c. Keyboard
Pull keyboard straight out from front
panel.
d. Sealing gasket
Carefully remove from front panel with
needle nose pliers. Clean any remaining
silicone compound from front panel.
INSTALLATION
e. Sealing gasket
f. Keyboard
Apply silicone compound to gasket.
CAUTION
The connector pins on the back of the keyboard are long and easily
bent. Carefully aline the keyboard with its mounting screw holes.
Insert the keyboard slowly and carefully until the pins are fully seated.
g. Four screws and flat
washers
Aline screw holes in keyboard with those
Feel for when the connec-
in front panel. Carefully insert keyboard.
tor pins meet the connec-
tor inside. If there is un-
usual resistance, do not
force. Remove and try
again.
Use cross tip screwdriver. Install four re-
tained screws and flat washers securing
keyboard to front panel.
2-173
|
