|
| TM 11-5820-890-10-8
SUBTASK
ACTIONS
RESULTS
b. Prepare ANCD to perform
Turn ANCD ON
(1)
select:
ICOM fill
SOi Radio supervisor
(2) Enter RADIO
Send Receive
sEtup Comsec Time
(3) Enter SEND
send to:
Radio Ancd Stu PC
(4) Enter RADIO
select: iCom Nonicom
Abn
Rcu** Haveq
Connect to RT AUD/FILL
(5) Enter ICOM
Connector
[↓]
Connect ANCD to RT and
(6)
Set FCTN switch to LD on RT
press down arrow
Do you want to include
Ensure FCTN is at LD and
(7)
time?***
press down arrow
Press [LOAD] on RT
(8) Enter YES
Transfer in progress
Press [LOAD] button on
c.
Perform ICOM fill on RT
(1)
RT keypad and observe
Note completion of ICOM
ICOM transfer successful
(2)
fill data transfer
[↓]
Load sync time manually
RT cannot accept time from
(3)
ANCD****
if required to do so
*
DATA control is found on the same key as the numeral "4."
**
Select "Rcu" to fill a Remote Control Unit (RCU) with COMSEC keys. The procedure is
the same as that shown for ICOM radio fill but only COMSEC is loaded, not FH data. (RCU does
not require FH data.)
***
Sync time is normally included for net opening only, not for net updates. Consult your
NCS or unit SOP for exact policy to follow.
****
If the RT being used willnot accept sync time as a part of the ICOM fill, this message will
appear. When it does, the operator must then manually load Julian Date and sync time into the
radio.
5-33
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |