LOAD SINGLE CHANNEL FREQUENCIES INTO RT

TM 11-5820-890-10-8

ACTIONS

SUBTASKS

RESULTS

c. Load SC freqs*

(1) Press [FREQ]

RT display shows [00000] or

[30000]

(2) Press [CLR]

RT display shows

(3)

Enter 5-digit SC freqs

RT display shows [X X X X X]

d. Store SC freqs

RT display blinks once

Press [STO] (within 7

seconds)

e. Prepare to communicate

(1)

Set FCTN to SQ ON

N/A

(SC, PT)**

(2)

Set CHAN to CUE, MAN, or

N/A

CHAN 1-6

(3)

Communicate in SC, PT

N/A

mode when desired

ANCD contains CUE, MAN, and some SC frequencies. Other SC frequencies to be loaded

in Channels 1-6 must be obtained from your NCS or SigO.

* * Operators normally do not load a CUE frequency; only NCS and alternate NCSs need to

receive CUE messages. The MAN frequency must be loaded if the Cold Start net opening

procedure is to be used. Channels 1 thru 6 are loaded with SC frequencies only when single

channel communications are known to be mission requirements. In a typical frequency hopping

net which uses the Hot Start net opening procedure, it is not necessary for the operator to load any

SC frequencies, at least until a specific need arises.

5-31