|
| TM 11-5820-670-30
2-43. A3000 MODULES AND ASSEMBLY REPLACEMENT. (CONT)
REMOVAL (CONT)
EL1AT012
10. Using screwdriver, loosen two captive screws (1).
11. Carefully pull P3001 (2) off pins (3).
Wires referenced in step 12 are located under assembly.
12. Disconnect black wire (P3301) from A3300 (4), red wire (P3701) from A3700 (5), green wire
(P3002) from FL3002 (6), and all wires from wire clips.
13. Remove hinge pin (7) from hinge (8).
14. Remove assembly (9).
INSTALLATION
CAUTION
Before installing assembly, ensure pins are not bent. Straighten any bent pins. Extreme
care must be taken not to damage pins.
1. Position assembly (9) in hinge (8) and install hinge pin (7).
NOTE
If modules were not removed from assembly, proceed to step 7 for installation of
assembly.
2-162
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |