Click here to make tpub.com your Home Page

Page Title: Audio Response Test (X-Mode) at 1 kHz
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



TM 11-.5820-401-34-3/0967-LP-432-3060
5-9. RECEIVER AUDIO RESPONSE TEST (X-MODE). (CONT)
2. Disconnect T-connector from AN/USM-207.
Audio Response Test (X-Mode) at 1 kHz
3. Set AN/USM-207 controls to the following positions:
POSITION/SETTING
CONTROL/SWITCH
I
TRACK
POWER
MIN (fully counterclockwise)
DISPLAY
0.1 v
SENSITIVITY
1 (black knob)
GATE TIME
FREQ
FUNCTION
4.
Disconnect rf cable from Adapter UG-514. (See test setup diagram
5.
Connect rf cable to AN/USM-207 FREQ A connector.
6.
Adjust AN/URM-127 FREQ RANGE DIAL for 1-kHz display on AN/USM-207.
7.
Disconnect rf cable from AN/USM-207 FREQ A connector.
8.
Reconnect rf cable to Adapter UG-514.
9.
Connect ME-30(*)/U INPUT lead A to Test Cable No. 1 terminal 2; connect lead B to
terminal A. Note meter indication.
STANDARD. ME-30(*)/U meter should indicate at least 0.78 volt.
10. If ME-30(*)/U meter does not indicate at least 0.78 volt, see troubleshooting chart 5-9.
Audio Response Test (X-Mode) at 500 Hz
11.
Turn AN/URM-127 FREQ RANGE DIAL to 50.
12.
Disconnect rf cable from Adapter UG-514. (See test setup diagram
.)
13.
Connect rf cable to AN/USM-207 FREQ A connector.
14.
Adjust AN/URM-127 FREQ RANGE DIAL for 500-Hz display on ANWSM-207.
15.
Disconnect rf cable from AN/USM-207 FREQ A connector.
16.
Reconnect rf cable to Adapter UG-514. Note ME-30(*)/U meter indication.
STANDARD. ME-30(*)/U meter should indicate between + 2db and -3 db of reading noted in
step 9.
17. If ME-30(*)/U meter does not indicate between + 2db and -3 db of reading taken in step 9, see
troubleshooting chart 5-9.
Audio Response Test (X-Mode) at 3 kHz
18.
Turn AN/URM-127 FREQ RANGE MULTIPLIER to x100.
19.
Turn FREQ RANGE DIAL to 30.
20.
Disconnect rf cable from Adapter UG-514. (See test setup diagram
.)
21.
Connect rf cable to AN/USM-207 FREQ A connector.
22.
Adjust AN/URM-127 FREQ RANGE DIAL for 3-kHz display on AN/USM-207.
23.
Disconnect rf cable from AN/USM-207 FREQ A connector.
24.
Reconnect rf cable to Adapter UG-514.
5-28


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business