Click here to make tpub.com your Home Page

Page Title: Audio Response Test (Normal Mode) at 500 Hz
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



TM
11-5820-401-34-3/0967-LP-432-3060
5-8. RECEIVER AUDIO RESPONSE TEST (NORMAL MODE). (CONT)
Audio Response Test (Normal Mode) at 1 kHz
3. Set AN/USM-207 controls to the following positions:
CONTROL/SWITCH
POSITION/SETTING
I
POWER
TRACK
DISPLAY
MIN (fully counterclockwise)
SENSITIVITY
0.1 v
GATE TIME
1 (black knob)
FUNCTION
FREQ
4.
Disconnect rf cable from Adapter UG-514. (See test setup diagram
5.
Connect rf cable to AN/USM-207 FREQ A connector (3).
6.
Adjust AN/URM-127 FREQ RANGE DIAL for 1-kHz display on AN/USM-207.
7.
Disconnect rf cable from AN/USM-207 FREQ A connector.
8.
Reconnect rf cable to Adapter UG-514.
9.
Connect ME-30(")/U INPUT lead A to Test Cable No. 1 terminal F; connect lead B to
terminal A.
10. Adjust R-442/VRC VOLUME control for 17-volt indication on ME-30(*)/U. Do not change
VOLUME control position during rest of test.
STANDARD. A 1-kHz modulating tone injected into the R-442/VRC should produce 17 volts at the
output.
11. If R-442/VRC VOLUME control adjustment cannot produce 17-volt indication on ME-30(*)/U,
see troubleshooting chart 5-10.
Audio Response Test (Normal Mode) at 500 Hz
12.
Turn AN/URM-127 FREQ RANGE DIAL to 50.
13.
Disconnect rf cable from Adapter UG-514. (See test setup diagram
.)
14.
Connect rf cable to AN/USM-207 FREQ A connector.
15.
Adjust AN/URM-127 FREQ RANGE DIAL for 500-Hz display on AN/USM-207.
16.
Disconnect rf cable from AN/USM-207 from FREQ A connector.
17.
Reconnect rf cable to Adapter UG-514.
STANDARD. ME-30(*)/U should Indicate between 14 and 22 volts,
18. If ME-30(*)/U indicates below 14 volts or above 22 volts, see troubleshooting chart 5-5.
Audio Response Test (Normal Mode) at 3kHz
19.
Turn AN/URM-127 FREQ RANGE MULTIPLIER to x100.
20.
Turn FREQ RANGE DIAL to 30.
21.
Disconnect rf cable from Adapter UG-514. (See test setup diagram
.)
22.
Connect rf cable to AN/USM-207 FREQ A connector.
23.
Adjust AN/URM-127 FREQ RANGE DIAL for 3-kHz display on AN/USM-207.
24.
Disconnect rf cable from AN/USM-207 FREQ A connector.
25.
Reconnect rf cable to Adapter UG-514.
5-24


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business