|
| TM 11-5820-401-34-3/0967-LP-432-3060
CHAPTER 5
DIRECT SUPPORT PERFORMANCE AND TROUBLESHOOTING
PROCEDURES USING TEST CABLE NO. 1 AND
DISCRETE TEST EQUIPMENT (TMDE)
Section
Page
Subject
I
Performance Tests . . . . . . . ............ . . .. . . . . . . . . . . . . . . . . . .
II
Troubleshooting . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . ..
Ill
Alinement and Adjustment Procedure. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..
OVERVIEW
This chapter contains performance tests, troubleshooting, and alinement procedures at thedirect
support level using Test Cable No. land discrete test equipment (TMDE).
The performance tests are diagnostic inpurpose. They should be used toverifythat an R-442/VRCis
operating properlyorto point out the existence of faults.
If failure to meet a performance test standard confirms that afaultis present inthe unit undervest, the
test procedure will refer you to a specific chart in the troubleshooting section. The troubleshooting
charts are designed to isolate the faults noted in the performance tests. They will guide you to the
source of defects and/or misalinements.
Once it has identified the source of a fault, a troubleshooting chart will refer you to the appropriate
repaidreplacement instructions or alinement procedure. Because each stage of the receiver
depends upon its other stages for overall operating efficiency, the replacement, repair, or
real inement of even one component could alter the signals enough to create the need for other
real inements. Therefore, after making any alterations in the R-442PJRC, do all the performance
tests, even those you have done already.
Section I PERFORMANCE TESTS
Para
Page
Subject
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
VOLUME Control Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Receiver Sensitivity Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NEW SQUELCH Test. . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OLD SQUELCH Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Receiver Audio Power Test . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Receiver Audio Distortion Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Receiver Audio Response Test (Normal Mode) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Receiver Audio Response Test (X-Mode) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Receiver Selectivity Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
GENERAL.
5-1.
This section contains performance test procedures for use with Test Cable No. 1 and discrete test
equipment (TMDE). They will enable you to determine whether or not an R-442/VRC is operating
acceptably. Each test procedure checks specific functions of the receiver to help you find and isolate
faults.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |