TB 9-2320-387-35-8
Route antenna cable (22) through vehicle body (2) to antenna base (24).
12-2.
Attach antenna cable (22) to antenna base (24).
12-3.
Remove locknut (12) from screw (15) on lower mounting position of reflector (14). Discard locknut (12).
12-4.
Install clamp (13) on antenna cable (22) and secure to existing screw (15) with locknut (12).
12-5.
Route antenna cable (22) along taillight wiring harness with two existing loop clamps (23) and (20),
12-6.
and secure with self-tapping screws (19).
NOTE
Left side antenna cable may not apply.
12-7. Route two antenna cables (21) and (22) along rear (26), two intermediate (28), and front (29) cargo
bed supports and along front wheelwell seam (7). Secure with three self-tapping screws (10) and
loop clamps (27), existing self-tapping screw (11) and loop clamp (25), screw (9), loop clamp (8), and
nut (6).
12-8. Coil antenna cable (22) and secure to inside of taillight closeout cover with tiedown strap (16).
12-9. Remove locknut (12) from screw (18) on upper mounting position of reflector (17). Discard locknut (12).
12-10. Install clamp (13) on antenna cable (22) and secure to existing screw (18) with locknut (12).
6
27 29
28
27
7
24
28
19
27
26
~
25
23
8
2
9
~
22
10
11
21
12
20
13
14
19
15
16
16
13
6.
LOCKNUT 271178 QTY. 1
12
8.
CLAMP, LOOP MS21333-99 QTY. 1
9.
CAPSCREW B1821BH025C088N QTY. 1
10.
SELF-TAPPING SCREW 9421073 QTY. 3
12.
LOCKNUT 271172 QTY. 2
13.
CLAMP, LOOP MS21333-98 QTY. 2
16.
TIEDOWN STRAP MS3367-1-0 QTY. A/R
17
18
21.
SINCGARS ANTENNA CABLE A3014031-17 QTY. 1
22.
SINCGARS ANTENNA CABLE A3014031-8 QTY. 1
27.
CLAMP, LOOP MS21333-68 QTY. 3
Figure 5-88.
5-76