TB 9-2320-387-35-8
12-22. Route two antenna cables (21) and (22) through right wheelwell/utility area with existing grommet,
retainer, screws, and plain-assembled nuts. (Refer to TM 9-2320-387-24.)
NOTE
Early production vehicles do not have SINCGARS installed.
Loop clamps and hardware on right rear seat/utility area and
tunnel shelf may or may not exist.
12-23. Remove screw (51), loop clamp (44), and locknut (43) from right wheelwell utility area (52).
Discard locknut (43).
12-24. Remove loop clamp (44) and self-tapping screw (10) from tunnel shelf (50).
12-25. Remove three self-tapping screws (48), loop clamps (47), washers (46), and evaporator wiring
harness (49) from tunnel insulation (45) and tunnel shelf (50).
12-26. Route two antenna cables (21) and (22) along right rear seat/utility area (52).
12-27. Secure two antenna cables (21) and (22) to tunnel shelf (50) with loop clamp (44) and self-tapping
screw (10).
12-28. Secure two antenna cables (21) and (22) to rear seat/utility area (52) with existing loop clamp (44),
screw (51), and locknut (43).
12-29. Route two antenna cables (21) and (22) under tunnel insulation (45) towards integrated rack.
12-30. Install tunnel insulation (45), and evaporator wiring harness (49) to tunnel shelf (50) with three
existing self-tapping screws (48), loop clamps (47), and washers (46).
44
10
43
45
48
47
46
21 22
~
~
~
49
52
51
50
10. SELF-TAPPING SCREW 9421073 QTY. 1
44. CLAMP, LOOP MS21333-68 QTY. 2
43. LOCKNUT 271166 QTY. 1
51. SCREW MS35206-267 QTY. 1
Figure 5-90.
5-78