Section XVII. CABLES INSTALLATION

TB 9-2320-387-35-3

Section XVII. CABLES INSTALLATION

NOTE

If soft top has been installed, roll back to allow clearance for

routing of antenna cable in steps 17-2 through 17-5.

Lay out all cables in their approximate positions before clamps are

installed. This will minimize the length, and ensure all slack is

taken out of all cables from front of vehicle to rear.

Excess slack in all cables will be stored under EPLRS mount

assembly.

It may be necessary to drill one 0.281-in. diameter hole in left side

of antenna base bracket for antenna cable clamp. (Refer to

figure 5-62.)

17-1. Locate, mark, and drill 0.281-in. diameter hole (8) in left overhead rail (6).

17-2. Route antenna cable (9) through hole (5) in overcab mount (1) and antenna base bracket (3), and

connect to antenna (2).

17-3. Install grommet (4) in antenna base bracket (3) and overcab mount (1).

17-4. Secure antenna cable (9) to left overhead rail (6) and antenna base bracket (3) with two

loop clamps (10), two capscrews (7), two lockwashers (11), and two nuts (12).

17-5. Route antenna cable (9) down along left overhead rail (6) and secure with loop clamp (10) and

existing screw (13).

17-6. Route antenna cable (9) to B-beam.

1.75

3.25

11 10

GROMMET MS21266-4N QTY. A/R

CAPSCREW B1821BH025C075N QTY. 2

EPLRS ANTENNA CABLE SM-C-911480 QTY. 1

10.

LOOP CLAMP MS21333-104 QTY. 3

11.

LOCKWASHER MS35338-44 QTY. 2

12.

NUT 9419143 QTY. 2

Figure 5-61.