 |
|||
|
|
|||
|
Page Title:
Section VI. FINAL ASSEMBLY, TERMINAL BOARD WIRING, AND TERMINAL LINK |
|
||
| ||||||||||
|
|  TB 9-2320-387-35-3
Section VI. FINAL ASSEMBLY, TERMINAL BOARD WIRING, AND TERMINAL LINK
NOTE
Refer to figure 5-10 for wiring overview.
Perform steps 6-1 and 6-2 if hole and grommet do not exist in
battery box.
If installing 24V terminal board only, begin with step 6-6.
6-1. Locate, mark, and drill 2.00-in. diameter hole (3) in upper right corner of rear wall of battery box.
6-2. Install grommet (4) in hole (3).
6-3. Secure terminal link (8) and fuse wire (7) to 12V terminal board (1) with two locknuts (6) and
install cover (5).
6-4. Route wire (2) through battery box hole (3).
3 X 24V FUSES, 25 AMP
EXISTING VEHICLE POWER STUD
POSITIVE FUSE WIRES
EXISTING VEHICLE BUSS BAR
24V BUSS BAR
GROUND WIRE
EXISTING VEHICLE SHUNT
POWER WIRE
GROUND STRAP
12V BUSS BAR
GROUND SCREW
12V FUSE, 15 AMP
VEHICLE BATTERY
VEHICLE BATTERY
2
3
1
4
4.
GROMMET 2400 QTY. 1
5.
TERMINAL BOARD COVER MS18029-3S-2 QTY. 1
6.
LOCKNUT 271175 QTY. 2
7.
FUSE WIRE ASSEMBLY (12V) 12480568-2 QTY. 1
8.
TERMINAL LINK MS25226-6N-2 QTY. 1
8
7
6
5
Figure 5-11.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals