|
| TB 9-2320-280-35-7
Section VIII. INSTALLATION OF SINCGARS MOUNTING TRAY AND AMP GUARD
8-1. Remove paint from vicinity of four mounting holes (6) on integrated rack (7) and vicinity of four
mounting holes (5) on bottom of mounting base (4).
8-2. Apply anti-seize compound to vicinity of four mounting holes (6) on integrated rack (7) and four
mounting holes (5) on bottom of mounting base (4) as required.
NOTE
Two lockwashers and one nut are used on driver's side screws
only.
8-3. Install mounting base (4) and amp guard (9) on integrated rack (7) with two capscrews (2), four
lockwashers (1), and two nuts (8). Secure mounting base (4) to integrated rack (7) with two
capscrews (3) and two lockwashers (1).
8-4. Place warning decal (10) on amp guard (9).
3
1
2
5
1
5
4
5
9
10
5
6
6
9
1
8
1.
LOCKWASHER MS45904-72 QTY. 6
7
2.
CAPSCREW B1821BH031F125N QTY. 2
3.
CAPSCREW B1821BH031F100N QTY. 2
4.
MOUNTING BASE, MT-6352/VRC A3013367-1 QTY. 1
8.
NUT MS51968-5 QTY. 2
9.
AMP GUARD 872842-1 QTY. 1
10.
DECAL 861868-2 QTY. 1
Figure 5-18.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |