Section XXXVI. PAN AND TILT MODULE (PTM) CONTROL ASSEMBLY, CONTROL CABLE ASSEMBLY, AND DCM/PTM INTERCONNECT CABLE INSTALLATION

TB 9-2320-280-35-3

Section XXXVI. PAN AND TILT MODULE (PTM) CONTROL ASSEMBLY, CONTROL CABLE

ASSEMBLY, AND DCM/PTM INTERCONNECT CABLE INSTALLATION

36-1. Locate, mark, and drill one 1.375-in. hole (1) for control cable seal assembly (2) on tunnel (3).

36-2. Position control cable seal assembly (2) and mark two hole locations (5).

36-3. Drill two 0.391-in. holes in marked locations (5).

36-4. Insert two rivet nuts (4) in tunnel (3).

36-5. Route DCM connector end of DCM/PTM interconnect cable (6) from transmission compartment

through hole (1) in tunnel (3), through control cable seal assembly (2), and into

driver's compartment.

36-6. For vehicles equipped with FBCB2, route PTM control cable assembly (8) through PTM control

mounting bracket (7).

NOTE

It may be necessary to remove azimuth lock cable adjusting nut to

route cabling.

36-7. Route two cables (8) and (9) from PTM control mounting bracket (7) through control cable seal

assembly (2).

NOTE

Holes in grommet must be enlarged to allow cables to fit.

36-8. Cut sides of four holes on control cable seal assembly's (2) grommet.

36-9. Route three cables (6), (8), and (9) from PTM control mounting bracket (7) into tunnel hole (1).

36-10. Route three cables (6), (8), and (9) along exhaust pipe (10), body mount (12), and oil filter (11).

Continue routing cables (6), (8), and (9) through engine compartment to A-frame cable guide (14) on

A-frame pillar flange (13) to PTM mount assembly (15).

6.50

2.00

2. CONTROL CABLE SEAL ASSEMBLY 3220908 QTY. 1

4. RIVET NUT 3221004-14 QTY. 2

Figure 5-117.