Section XXXV. PAN AND TILT MODULE (PTM) CONTROL MOUNTING BRACKET INSTALLATION

TB 9-2320-280-35-3

Section XXXV. PAN AND TILT MODULE (PTM) CONTROL MOUNTING BRACKET INSTALLATION

NOTE

SINCGARS mount and amp guard share existing mounting

hardware with PTM control mounting bracket.

35-1. Remove SINCGARS mount and amp guard if necessary. (Refer to chapter 5, section VIII.)

35-2. Using existing hole (5) and PTM control mounting bracket (1) as template, locate, mark, and drill

two 0.281-in. holes (6) on integrated rack (2).

NOTE

SINCGARS mount and amp guard must be in place before PTM

mount is installed.

35-3. Install SINCGARS mount and amp guard if removed. (Refer to chapter 5, section VIII.)

35-4. Install PTM control mounting bracket (1) on integrated rack (2) with two capscrews (10), four

washers (8), two locknuts (7), and existing screw (3), two lockwashers (4), and nut (9).

PTM CONTROL MOUNTING BRACKET 3236630-1 QTY. 1

LOCKNUT M45913/4-4CG8Z QTY. 2

WASHER 2436161 QTY. 4

10.

CAPSCREW B1821BH025C100N QTY. 2

Figure 5-116.