Section XX. MTS MOUNT AND PLGR BRACKET INSTALLATION

TB 9-2320-280-35-3

Section XX. MTS MOUNT AND PLGR BRACKET INSTALLATION

NOTE

Ensure all holes have been drilled and inserts installed. (Refer to

chapter 5, section VII.)

When attaching lower ball to MTS mounting bracket, leave left

rear hole open to accommodate future loop clamp and MTS

display wire.

20-1. Position spacer (12) between insert (13) and MTS mounting base bracket (15). Attach MTS mounting

base bracket (15) to floor (14) with three lockwashers (7), washers (2), and capscrews (16).

20-2. Attach PLGR bracket (8) to MTS mounting base bracket (15) with lockwasher (7), capscrew (11),

washer (2), lockwasher (7), and capscrew (6).

20-3. Attach PLGR mount (4) to PLGR bracket (8) with four screws (5), lockwashers (9), and nuts (10).

20-4. Fabricate ground strap (18) from 6-in. length of braided wire and two terminal lugs.

NOTE

Ground strap will be installed on lower ball mount only at this

time. Other end of ground strap will be installed with MTS display

cables. (Refer to chapter 5, section XXVI.)

20-5. Install ground strap (18) and lower ball mount (19) on MTS mounting base bracket (15) with three

capscrews (1), six washers (2), and three locknuts (17). Leave hole (3) open for future loop clamps

and MTS display wire.

CAPSCREW B1821BH025C113N QTY. 3

12. SPACER 12340849 QTY. 1

WASHER 2436161 QTY. 12

15. MTS MOUNTING BASE BRACKET RCSK-19648

PLGR BRACKET 986-0645-001 QTY. 1

QTY. 1

SCREW MS35206-263 QTY. 4

16. CAPSCREW B1821BH25C125N QTY. 3

CAPSCREW B1821BH025C150N QTY. 1

17. LOCKNUT MS51943-31 QTY. 3

LOCKWASHER MS35338-44 QTY. 5

18. GROUND STRAP

PLGR MOUNT BRACKET 12480576 QTY. 1

BRAIDED WIRE AA59569F30T0375 QTY. A/R

LOCKWASHER MS35338-43 QTY. 4

TERMINAL LUG MS20659-107 QTY. 1

10.

NUT 9422771 QTY. 4

TERMINAL LUG MS20659-141 QTY. 1

11.

CAPSCREW B1821BH025C075N QTY. 1

19. LOWER BALL MOUNT D254 QTY. 1

Figure 5-63.