Locate, mark, and drill one 0.147-in. hole

TB 9-2320-280-35-3

15-19. Locate, mark, and drill one 0.147-in. hole (35) in top of windshield frame (30).

15-20. Route PLGR antenna cable (9) on top of windshield frame (30) and secure with loop clamp (26) and

self-tapping screw (25).

15-21. Route PLGR antenna cable (9) down through center access hole (29) of integrated rack (31), and coil

excess antenna cable (9) under integrated rack (31).

15-22. Route PLGR power cable (33) from bracket (32) to right-side tunnel insulation (34).

NOTE

Loosen right-side tunnel insulation before performing step 15-23.

(Refer to TM 9-2320-280-20.)

15-23. Route PLGR power cable (33) under edge of right-side tunnel insulation (34) to 24V terminal bar at

cab enclosure panel.

25. SELF-TAPPING SCREW 9421073 QTY. 1

26. LOOP CLAMP MS21333-65 QTY. 1

31. PLGR POWER CABLE 9728558-10 QTY. 1

Figure 5-49.

5-37