Section XIX. EPLRS CABLES INSTALLATION

TB 9-2320-280-35-2

Section XIX. EPLRS CABLES INSTALLATION

NOTE

If soft top has been installed, roll back to allow clearance for routing

of antenna cable in steps 19-2 through 19-5.

Lay out all cables in their approximate positions before clamps are

installed. This will minimize the length, and ensure all slack is

taken out of all cables from front of vehicle to rear.

Excess slack in all cables will be stored under EPLRS mount

assembly.

This procedure applies to installation of EPLRS cables without MTS

installed. Installation of EPLRS cables with MTS is similar.

It may be necessary to drill one 0.281-in. hole in left side of antenna

base bracket for antenna cable clamp. (Refer to figure 5-63.)

19-1.

Locate, mark, and drill 0.281-in. hole (8) in left overhead rail (6).

19-2.

Route antenna cable (9) through hole (5) in overcab mount (1) and antenna base bracket (3) and

connect to antenna (2).

19-3.

Install grommet (4) in antenna base bracket (3) and overcab mount (1).

19-4.

Secure antenna cable (9) to left overhead rail (6) and antenna base bracket (3) with two

loop clamps (10), capscrews (7), lockwashers (11), and nuts (12).

19-5.

Route antenna cable (9) down along left overhead rail (6) and secure with loop clamp (10) and

existing screw (13).

1.75

3.25

4.50

GROMMET MS21266-4N QTY. A/R

CAPSCREW B1821BH025C075N QTY. 2

EPLRS ANTENNA CABLE SM-C-911480 QTY. 1

10.

LOOP CLAMP MS21333-104 QTY. 2

11.

LOCKWASHER MS35338-44 QTY. 2

12.

NUT 9419143 QTY. 2

Figure 5-63.