|
| TB 9-2320-280-35-13
NOTE
Perform step 23-4 for vehicles with left rear cab enclosure panel
only.
23-4. Cut 2x2 in. section (13) from left rear cab enclosure panel (11). Install grommet (12). Reinstall cab
enclosure panel (11). (Refer to TM 9-2320-280-20.)
23-5. Locate, mark, and drill three 0.147-in. holes (8) along tunnel edge (9).
23-6. Route INC-EPUU cable (1) and power cable (4) rearward under left-side B-beam (10) and along
tunnel edge (9).
23-7. Route INC-EPUU cable (1) and power cable (4) rearward along tunnel edge (9) and secure with
three clamps (7) and self-tapping screws (6).
4
1
2.00
12
10
5.50
11
6
2.00
7
8
0
2.0
6
13
B-PILLAR
7
0
11.0
8
6
7
0
11.0
8
6. SELF-TAPPING SCREW 9421073 QTY. 5
8.00
7. LOOP CLAMP MS21333-75 QTY. 2
9
12. GROMMET MS21266-1N QTY. A/R
Figure 5-91.
5-71
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |