 |
|||
|
|
|||
|
Page Title:
Figure 2-7. shows typical df setup. |
|
||
| ||||||||||
|
|  TM 32-5895-206-10
(11) Connect radio frequency (RF) cable to connector
in antenna base. Connect other end of RF cable to radio
receiver which will be used. Use ANT 2 connector of receiver.
(12) Loosen mast retaining screw to allow mast and
antenna to rotate.
(13) Check setup to be sure that all steps have been
done properly.
Figure 2-7. shows typical df setup.
2-6 BATTERY CHECK AND REPLACEMENT PROCEDURES.
Before operating the equipment, check the 2-44
2-44
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals