Section I. INTRODUCTION - TM-11-5895-532-34P-30004

TM 11-5895-532-34P-3

SECTION I

INTRODUCTION

1. Scope

XD-A support item that is not stocked. When required,

This manual lists spares and repair parts; special tools;

item will be procured through normal supply

special test, measurement, and diagnostic equipment

channels.

(TMDE), and other special support equipment required

NOTE

for performance of direct support and general support

maintenance of the CP925/TPX46(V). It authorizes the

Cannibalization or salvage may be used as a

requisitioning and issue of spares and repair parts as

source of supply for any items source coded

indicated by the source and maintenance codes.

above except those coded XA and aircraft

support items as restricted by AR 70042.

2. General

(2) Maintenance code. Maintenance codes are

This Repair Parts and Special Tools List is divided into

assigned to indicate the levels of maintenance authorized

the following sections:

to USE and REPAIR support items. The maintenance

a. Section II. Repair Parts List. A list of spares and

codes are entered in the third and fourth positions of the

repair parts authorized for use in the performance of

Uniform SMR Code format as follows:

maintenance. The list also includes parts which must be

(a) The maintenance code entered in the third

removed for replacement of the authorized parts. Parts

position will indicate the lowest maintenance level

lists are composed of functional groups in numeric

authorized to remove, replace, and use the support item.

sequence, with the parts in each group listed in figure

The maintenance code entered in the third position will

and item number sequence.

indicate one of the following levels of maintenance:

B. Section III. Special Tools List. Not applicable.

Code

Application Explanation

c. Section IV. National Stock Number and Part

O-Support item is removed, replaced, used at the

Number Index. A list, in National item identification

organizational level.

number (NIIN) sequence, of all National stock numbers

F-Support item is removed, replaced, used at the

(NSN) appearing in the listings, followed by a list, in

direct support level.

alphameric sequence, of all part numbers appearing in

H-Support item is removed, replaced, used at the

the listings. National stock numbers and part numbers

general support level.

are cross-referenced to each illustration figure and item

D-Support items that are removed, replaced, used

number appearance.

at depot, mobile depot, specialized repair

3. Explanation of Columns

activity only.

a. Illustration. This column is divided as follows:

(b) The maintenance code entered in the fourth

(1) Figure number. Indicates the figure number of

position indicates whether the item is to be repaired and

the illustration on which the item is shown.

identifies the lowest maintenance level with the capability

(2) Item number. The number used to identify item

to perform complete repair (i.e., all authorized

called out in the illustration.

maintenance functions). This position will contain one of

b. Source, Maintenance, and Recoverability (SMR)

the following maintenance codes:

Codes.

Code

Application/Explanation

(1) Source code. Source codes indicate the

H-The lowest maintenance level capable of

manner of acquiring support items for maintenance,

complete repair of the support item is the general

repair, or overhaul of end items. Source codes are

support level.

entered in the first and second positions of the Uniform

D-The lowest maintenance level capable of complete

SMR Code format as follows:

repair of the support item is the depot level.

Code Definition

Z-Nonreparable. No repair is authorized.

PA--Item procured and stocked for anticipated of

known usage.