Battery Pack Assembly

b. Battery Installation. Refer to Chapter 3 paragraph 3-7 to install or replace the batteries.

c. Battery Pack Assembly. To attach the battery pack power source to the radio, refer to Figure 2-2 and

perform the following steps:

(1) Ensure pull ring on battery supply is flat against top of supply.

(2) Position the R/T unit over the battery power supply so that the R/T and power supply connectors are

aligned.

(3) Slowly lower R/T onto power supply.

(4) Gently press downward on case to seat the connectors.

(5) Press down on snap fastener levers until levers snap into place.

WARNING

Fasteners (4) are spring-loaded and snap into place. Use thumb or heel of hand

when securing power source to the R/T catches (2) to prevent injury.

d. Antenna Assembly. To attach antenna to the R/T, perform the following steps:

2-15