|
| TM 11-5895-1141-34
Table 4-8. TRANSMIT CIRCUITS TEST PROCEDURE (Cont'd)
Step
Operation
Normal Indication
9
a. Reconnect ac voltmeter to transmitting
output terminals, across 600 ohm load
resistor (fig. 4-7).
b. Disconnect audio oscillator.
c. Connect a short circuit across attenu-
Noise level should not exceed -50 dBm.
ator output.
d. With no signal applied measure trans-
mitting output noise level.
10
Check continuity to transmitter keying
Continuity should be indicated between pins
line using an ohmmeter.
4, 18 or pins 1, 17 of J201.
11
For each additional channel used, repeat
steps 1 through 10. Refer to figure FO-15
for connecting to J201 and J202 for trans-
mitting audio and keying terminals on
other channels.
12
Remove the audio signal source from the
microphone input leads to the dual plug
upon completion of all tests.
4-17
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |