SECTION I. INTRODUCTION - TM-11-5840-352-24P0003

TM11-5840-352-24P

SECTION I

INTRODUCTION

1. Scope

Definition

CO&

This manual lists spares and repair parts; special

PA -Item procured and stocked for anticipated or

tools; special test, measurement, and diagnostic

known usage.

equipment (TMDE), and other special support, equip-

XD --A support item that is not stocked. When re-

ment required for performance of organizational,

quired, item will be procured through nor-

direct support, and general support maintenance of

mal supply channels.

the AN/GSQ-160, OH-29/GSQ-160. It authorizes

the requisitioning and issue of spares and repair parts

as indicated by the source and maintenance codes.

Cannibalization or salvage may be used as

a source of supply for any items source

2. General

coded above except those coded XA and air-

craft support items as restricted by AR

This Repair Parts and Special Tools List is divided

700-42.

into the following sections:

Section II. Repair Parts List. A list of spares and

(2) Maintenance code. Maintenance codes are

repair parts authorized for use in the performance of

assigned to indicate the levels of maintenance

maintenance. The list also includes parts which must

authorized to USE and REPAIR support items. The

be removed for replacement of the authorized parts.

maintenance codes are entered in the third and fourth

Parts lists are composed of functional groups in

positions of the Uniform SMR Code format as

numeric sequence, with the parts in each group listed

follows:

in figure and item number sequence.

(a) The maintenance code entered in the third

b. Section. III. Special Tools List. Not applicable.

position will indicate the lowest maintenance level

c. Section IV. National Stock Number and Part

authorized to remove, replace, and use the support

Number Index. A list, in National item identification

item. The maintenance code entered in the third posi-

number (NUN) sequence, of all National stock

tion will indicate one of the following levels of

numbers (NSN) appearing in the listings, followed by

maintenance:

a list, in alphameric sequence, of all part numbers

appearing in the listings. National stock numbers and

Code

Application/Explanation

part numbers are cross-referenced to each illustra-

tion figure and item number appearance.

-Support item is removed, replaced, used at

the organizational level.

3. Explanation of Columns

F -Support item is removed, replaced, used at

the direct support level.

H -Support item is removed, replaced, used at

a. Illustration This column is divided as follows:

(1) Figure number. Indicates the figure number

the general support level.

of the illustration on which the item is shown.

D -Support items that are removed, replaced,

(2) Item number. The number used to identify

used at depot, mobile depot, specialized re-

item called out in the illustration.

pair activity only.

b. Source, Maintenance, and Recoverability (SMR)

codes.

(b) The maintenance code entered in the

(1) Source code. Source codes indicate the

fourth position indicates whether the item is to be

manner of acquiring support items for maintenance,

repaired and identifies the lowest maintenance level

repair, or overhaul of end items. Source codes are

with the capability to perform complete repair (i.e.,

entered in the first and second positions of the

all authorized maintenance functions). This position

R Code format as follows:

will contain one of the following maintenance codes: