SECTION IV CABLE REMOVAL AND REPLACEMENT

TM 11-5830-263-20&P

3.10.4 Spring Cover Pad Removal Procedure and Replacement Procedure (Fig. 3-27)

a. Removal

Unsnap spring cover pad (1) and remove.

b. Replacement

Wrap spring cover pad (1) around spring assembly (6) ensuring snap side is up, and secure in

place

3.10.5 Side Pad Removal and Replacement Procedures (Fig. 3-27)

a. Removal

Press end of spring assembly (6) into side pad (7). Tilt spring assembly (6) away from side pad

(7) and remove side pad (7).

b. Replacement

Insert end of spring assembly (6) into slot on side pad (7) and secure.

SECTION IV CABLE REMOVAL AND REPLACEMENT

There are no specific procedural steps for and replacing VIS cabling. Ensure that the power is removed

from the MCS prior to removing and replacing VIS cabling. Utilize the vehicle layout diagrams in Chapter

2, and if necessary the appropriate Vehicle Technical Bulletin, for the proper VIS cable routing.

Additionally, when removing VIS cabling, identify the locations where the cabling is tied down or secured,

when cabling is replaced the new cable is to be routed in the same manner, to stop accidental damage.

Ensure that all cable tie-down locations are used and/or replaced (tie-wraps).