Socket Blanking Plug Removal and Replacement (CAPS Type 1) (Fig. 3-26)

TM 11-5830-263-20&P

3.9.9.

Socket Blanking Plug Removal and Replacement (CAPS Type 1) (Fig. 3-26)

If the socket blanking plug is deteriorated or missing replace as shown in Fig. 3-26.

SOCKET

BLANKING

PLUG

Figure 3-26. Socket Blanking Plug (CAPS Type 1)

3.10.

COMMAND AND CONTROL HEADSET COMPONENTS REMOVAL AND REPLACEMENT

PROCEDURES (FIG. 3-27)

CAUTION

THE COMMAND AND CONTROL HEADSET CONTAINS AN EARPHONE WITH WIRE

CONNECTIONS (8 OF FIGURE 3-27) THAT MUST BE HANDLED VERY CAREFULLY

WHEN THE FOAM EARPHONE HOLDER IS REMOVED FROM THE EARCUP.

NOTE

Removal and replacement procedures for the microphone, boom assembly and mounting

hardware are identical to the procedures described in previous paragraphs for other

headsets. The microphone cable assembly cannot be removed and replaced, as it is part

of the headset.

3.10.1. Microphone Removal and Replacement Procedures (Fig. 3-27)

For microphone removal and replacement refer to paragraph 3.9.6.

3.10.2. Boom Assembly/Mounting Hardware Removal and Replacement Procedures (Fig. 3-27)

For boom assembly/mounting hardware removal and replacement refer to paragraph 3.8.6.

NOTE

The microphone cable assembly cannot be removed, as it is hardwired in.