LINE REPLACEABLE UNITS (LRUs) MOUNTING SEQUENCES

TM 11-5830-263-20&P

3.7.

LINE REPLACEABLE UNITS (LRUs) MOUNTING SEQUENCES

The following steps describe the procedures for using the Tables and their corresponding Figures in

identifying the correct mounting sequences of the various LRUs.

a. Identify which LRU (MCS, FFCS, MOS, RIT) is being removed and replaced and refer to one of

the following tables:

Table 3-1 MCS Mounting Hardware (Fig. 3-6)

Table 3-2 FFCS Mounting Hardware (Fig. 3-7)

Table 3-3 MOS Mounting Hardware (Fig. 3-8)

Table 3-4 RIT Mounting Hardware (Fig. 3-9)

b. Find the "VEHICLE" column of the appropriate Table and identify the vehicle you are in.

Find the "CREW STATION"/"ITEM" (FFCS, MOS, RIT) column of the appropriate Table and

identify the LRU that is being removed and replaced for the selected vehicle.

d. Find the "MOUNTING SEQUENCE" column of the appropriate Table and identify the mounting

sequence that corresponds to the LRU being removed and replaced.

e. Find the Figure that corresponds with the selected Table and match the mounting sequence

selected from the Table with the mounting sequence in the Figure.

NOTE

The Mounting Hardware Sequence Figures (Figure 3-6, 3-7, 3-8, 3-9), show the ground

strap for sequencing purposes only. For the correct location of the ground strap (left,

right, top or bottom of the LRU) refer to the appropriate vehicle TB (Table 1-1).

Table 3-1. MCS Mounting Hardware (Figure 3-6)

MOUNTING

VEHICLE

SEQUENCE

M1A1 ABRAMS, M1A2 ABRAMS

M2A2 BRADLEY, M3A2 BRADLEY

M577 COMMAND POST

M109A6 PALADIN

M1068 SICPS TRACKED

S-787 SICPS RIGID WALL

M2A2 ODS BRADLEY, M3A2 ODS BRADLEY

HAB

M992 FAASV

M7 BFIST

M88A2 RECOVERY VEHICLE

#10

ASV

#11

MLRS

#12

GRIZZLY (BREACHER)

STRIKER

#12

3-6