|
| TM11-5830-263-20&P
SECTION VI
TROUBLESHOOTING OF CABLE ASSEMBLIES
2.10.
TROUBLESHOOTING OF CABLE ASSEMBLIES
When a Cable Assembly is identified in Section(s) IV or V of this Chapter as the failure item, refer to the
Vehicle System Configuration Figures in Section II of this Chapter to identify the correct number of the
cable. Identify the Part number and refer to Appendix H (Cable Assemblies, Pin Identification, Common
Names and Signal Names) for the internal wiring and pin configuration of the cable.
Use a Multimeter set on "Continuity" or "Ohms" to perform a pin to pin check of the cable assembly using
the internal wiring schematic and pin identification in Appendix H.
If the cable is found defective, refer to Chapter 3 for the Removal and Replacement Procedures.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |