|
| TM-11-5830-263-20&P
SECTION V
SYSTEM TROUBLESHOOTING WITH ERROR SHOWN ON ALPHANUMERIC
DISPLAY
CAUTION
BE SURE TO REMOVE POWER FROM THE MCS BEFORE REMOVING OR
REPLACING COMPONENTS AND/OR CABLES.
2.9.
TROUBLESHOOTING WITH ALPHANUMERIC ERROR DISPLAY
a. General
The procedures in step b below troubleshoot faulty equipment in VIS with an error message (s)
displayed on the MCS alphanumeric display. They apply whether trouble is in radio or intercom
communication. For vehicles in a ring configuration, refer to Table 2-4. For vehicles in a two-
branch configuration, refer to Table 2-5.
NOTE
Ensure that Para. 2.3. "Equipment Inspections/Checks/Guidelines" has been followed
prior to beginning any troubleshooting procedures using Tables 2-4 or 2-5.
b. Troubleshooting the system
Perform the following steps in sequence to ensure accurate troubleshooting of the equipment.
1. Determine whether the vehicle has a ring or two-branch configuration.
2. Go to appropriate Table, 2-4 or 2-5.
3. Examine the "MCS Alphanumeric Display" column to find the error message that matches
the one on the MCS display, while at the same time examine the "Error Description"
column to correctly identify the corresponding problem.
4. Perform the action required as stated in the corresponding "Corrective Measures"
column.
NOTE
Reference to "substitution of a VIS box with a known good one" in the troubleshooting
flowcharts refers to properly configured (Section III) and operationally verified
replacement equipment.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |